Поговорим о Klipsch…, Общее об акустических системах Klipsch, среднего и высшего уровня...

Да,просим.

Ну что, мля... всем интересно про Вавак с Клипшами... у Вас телефон совсем горячим будет...

"Он то плакал, то смеялся, то щетинился как ёж,
Он над нами издевался. Ну сумасшедший, что возьмешь?"

Вот эта чё!

Sound Valves is the name taken after Dynaco stopped selling DIY kits in the 1990s and set up shop in Columbus Ohio. The M60 amplifier could be considered the next version of the Dynaco MKIII. The parts used on these amps, aside from chassis and main board, follow the Dynaco design principal of being readily available – most parts are available from either Mouser or most tube suppliers. There is great support out there for anything Dynaco and that includes these amps. Any place that repairs or mods Dynaco equipment can work on these amps.

The M60 audio circuit topology is a four stage, single channel power amplifier. The front end consists of an all triode, Class A gain stage, phase splitter, and low impedance drivers. The output stage uses 6550 tubes and operate in triode or ultra-linear mode selected by a switch between the output tubes and transformers (NOTE: Manual states the switch can only be used when amp is off). In triode / ultra-linear mode the first 17W / 30W are pure Class A, switching to Class AB1 for a maximum RMS output of 30W / 60W. Below is the information from the manual.

ULTRALINEAR: 60 watts (into 2, 4, or 8 ohms). THDIIM (60 watts RMS, 20-20kHz): <0.5%; @1kHz: <0.1%. Frequency Response: 20-20kHz, +0/-.25dB. Full Power Bandwidth: 5-75kHz, +0/-3dB.

TRIODE: 30 watts (into 2, 4, or 8 ohms). THD+N (30W RMS, 20-20kHz): <0.8%; THD @1kHz: <0.2%. Frequency Response: 20Hz-20kHz, +0/-0.5dB. Full Power Bandwidth: 6-60kHz.

GENERAL: Input impedance: 300K ohms. Output impedance: <0.70. Max.power be­ fore clipping: 70 watts. Dynamic headroom: 1.2dB. Signal-to-noise ratio (@60W): down better than 95dB. Input sensitivity: 1.2VRMS for 60W; (200mv for 1 watt; l.0V for 30 watts triode). Gain: +22.4dB (20 dB negative feedback). Polarity: non­ inverting.
USA Tubes: 2-6550A, 1-12AT7/6201, 1-12AU7/5963.
Case Dimensions: 9-1/2"W x 7-1/2"Hx 11"D (12"D including binding posts). Net Weight: 32 lbs.

Вот чего ещё нарыл
http://www.bvi.ru/old/soundval.html

Вот немного жоп
https://www.avito.ru/moskva/audio_i_video/lampovyy_predusilitel_sound_valves_v­tp-101_usa_760266743