Denon DVD-3930

Сегодня начал опять переписку с РГ Сервисом по поводу прошивки чипа Realta, может, кто ещё надавит на Сервисы. Вот информация о том, чего должны исправить в прошивке, взято с немецких сайтов:
1."DENON GERMANY HEAD QUARTERS EUROPE

Very honoured the on customer, cordial thanks for your numerous letters concerning the
De-Interlacing-problems of the DVD-3930 with selected PAL-Film material.

After detailed examination in the quality assurance, we optimized the core firmware of the
De-Interlacers of the DVD-3930 in co-operation with the chip manufacturer with PAL -Film material in the auto mode so far as possible.
In particular by the optimization the following problems were repaired:

- brief arising comb effects (education horizontal black strip) with fast movements
(in particular in bright display spaces) with selected PAL -Film material

- general improvement of the De-Interlacing-performance with selected difficult PAL -Film material (prevention of the occurrence of line flares on diagonal lines, improvement of the edge smoothing) to the chip limit

- recovery of memory problems "progressive fashion" The actualization of the core firmware silicone of the Optix material TA chip requires an interference into the DVD-3930.
Depending upon status of the video board if necessary also a board exchange is necessary.
Therefore the update must be accomplished in each case only in an authorized DENON service workshop.
According to the guarantee conditions you please exclusively contact for a modification of your DVD-3930 your authorized the one dealer, with whom you acquired the equipment.
Attach this letter to the equipment, in order to shorten the time of the warranty repair completion.
Alternatively you use please as error description: "problems with the De-Interlacing with selected PAL -Film material in the auto mode" Cordial thanks for your patience and your understanding.
Yours sincerely, Product information team DENON Germany – division”

2."DENON Dear customer,

Thank you for your many letters regarding the de-interlacing problems of the DVD-3930 when elected PAL footage.

After a thorough examination in the quality assurance, we have in collaboration with the chip manufacturer nuclear firmware De-Interlacers the DVD-3930 at PAL footage in AUTO mode, as far as best as possible.
In particular, the optimization of the following problems:


-- Short occurring ridge effects (Education black horizontal stripes) for fast movements (especially in bright image areas) when elected PAL footage


-- Improvement of de-interlacing performance of elected difficult PAL footage (prevention of the occurrence of an Zeilenflimmern diagonal lines, improving anti-aliasing) up to the limit chip


-- Resolving problems of memory? Progressive Mode?


Updating the firmware core of the Silicon Optix REALTA chip requires an encroachment on the DVD-3930. Depending on the status of the video boards is necessary, a board-swapping is necessary. Therefore, the fix in any case only in an authorized DENON service workshop.

According to the warranty conditions apply for a modification of your DVD-3930 exclusively to please your DENON authorized dealer from whom you purchased the unit"

Посвящается Китайским ценам!
http://www.100hifi.com/sublist.asp?LarCode=DENON(??)&MidCode=AV??
10800=1т80$ США и так все остальное.

Здравствуй Станислав! А что писать то , пользуюсь и рад во всём. По твику пока не известно , давайте ветку сделаем , может кто что подскажет? Через пару месяцев в плане Denon 2807 на AV11 поменять, вот там я думаю будет о чём писать , а может AV1 осилю , но только б/у , но я не брезгаю. Только вот сначала  с усом решу , хочу я лампу и всё тут.

Что касаемо ветки обращаюсь к народу ,кто может посоветовать,какой приобрести  ламповый усилитель ценовой категории от 2х до 3х тыс $$$$!
Ждем ответа.