рега, проджект или голдринг?

да и от пыли помощь

В Германии нету пыли, ты чё, забыл.

Improved современная модификация СМЕ с пластиковыми подшипниками, что плохо.
До нее они были стальными, что хорошо.
Можно заказать бронзовые (99 футов анг), что опять хорошо.

SME 3009 Series II, SME 3012 Series II (until 1972)
Click here for the manual (9 JPEGs) More pictures : early 3012 Series II (two-piece counterweight)
Aluminum arm tube, steel knife-edge bearings. Effective mass 12,5g (3009) or 14g (3012). Barrel-shaped main counterweight, different sizes for 3009 and 3012. Main counterweight locked in place using allen bolt. VTF set using outrigger. Outrigger can be split into two pieces to change the range and precision of VTF
(one : up to 2.5g, both : up to 5g). Lateral balance is adjusted by changing the distance of the outrigger from the main counterweight. Antiskating adjustment by thread and weight, long axle with 10 notches.

Shortly after SME went out of production with the Series II tonearms the Improved was introduced.
There were two versions - with fixed or detachable headshell - but the arm was available in 9" length only. The Improved was intended for the use with high-compliant cartridges and had therefore a quite low effective mass.
SME 3009 Improved, SME 3009 S2 Improved
Click here for the manual (16 JPEGs)
3009 Imp: fixed headshell. 3009 S2 Imp: detachable headshell. Aluminum arm tube, effective mass 9,5g (3009 Imp) or 12,5g (3009 S2 Imp). Nylon knife-edge bearings. One-piece disc-shaped counterweight, threaded. VTF set using outrigger, one weight. VTF range: 0 -1.5g. Lateral balance is set by adjusting the position of the outrigger relative to the main counterweight. Antiskating adjustment by thread and weight, short axle with 6 notches.
Null points : 66 and 121mm.
Mounting distance (bedplate centre to turntable centre) : 215,4mm.
The differences to the Series II arms are easily recognizeable by looking at the weights.
Since a lot of users found the Improved arms inferior to their predecessors and due to their lightweight construction it turned out to be unsuitable for low-compliant cartridges like Ortofon SPU or Denon DL 103 SME decided to produce a new series of heavier tonearms again (from 1981).

Возвращаясь к теме Прджекта ))) должен заметить, что он все-таки жжот. С удивлением для себя тот самый диск Roxy Music уже третий раз слушаю, а компакт на дорогом сидюке хоть и купил пол-года назад, так и не послушал целиком. Да, все там слышнее, но чего-то не хватает, видно аналоговые штучки человеческому уху роднее, как ни крути. Похоже так на винил и подсаживаются )))

 Похоже так на винил и подсаживаются )))

Добро пожаловать в АД.